đź“„ System Settings (v2.4)

System Settings


Settings are where you tailor Mimic to your setup.

Once you land in Settings, to begin with, you have a description of Mimic Core, its intended use and software version.

On the top right side, you can see what kind of Mimic licenses you have available. Reach out to our sales team to learn more about licenses.

What you can control here:

  • Network

    Configure the network settings of the Mimic Controller.

    If preferred, the IP address of the Mimic Controller can be changed through the Mimic software. 

    1. Press the “SETTINGS” button from the home page of the Mimic software 

    2. Press the “NETWORK” tab from the settings page to enter the network settings page.  

    3. Manually configure the IP address by setting the network mode to “STATIC” and enter the desired IP address and subnet mask in the “IP” and “Subnet” fields.  

    4. Alternatively, the “DHCP” network mode can be chosen, to let the Mimic Controller receive an IP address automatically. Note that an IP address will only be assigned if a DHCP server is present on the network.  

    5. Press the “Save” button in the bottom right corner of the network settings page to apply the settings.  

  • General

    1. Choose whether to use an onscreen keyboard or connect an external one.

    2. Specify whether outputs should be on when pausing/stopping a program.

    3. Enable or disable outputs by default when creating new Recordings.

    4. Enable or disable outputs by default when running programs.

    5. Enable option to resume a running program from last interruption.

    6. Enable debugging mode. If debugging mode is enabled additional information is provided in log. This is beneficial if edge cases are being tested, and exporting for support.

    7. Set language.

    8. Release robot control after execution stops in external control mode (Control from Robot).

    Mimic has control of the robot when running a program. This function will release this control, if "Stop" is called.

    7. Loop execution of single Recordings. Hence, the same Recording can be looped without creating a Program with 1 Recording.

    9. Enable logging of execution data. Can be used to analyse data.

  • Launch Nordbo Update Tool

    Launches the Nordbo Update Tool directly from Mimic Core.