đź“„ Mimic Controller Setup (v2.4)

Mimic Controller Setup


What you need prior to Mimic installation

‍

  • Full HD touch monitor (1080p) (22" is recommended) with mouse and keyboard

  • Gigabit switch (optional - needed if connecting other hardware to the robot)

  • Ethernet cables long enough to reach from your teaching station to the robot

Recommendations for powder coating setups

When selecting a monitor for powder coating setups, we recommend using and industrial monitor with IP65 and ATEX / IECEx Zone22.

The Mimic Controller

The Mimic Controller is where the Mimic software runs.

To set it up:

  • Connect the power supply to the Mimic Controller

  • Connecting the Mimic Controller to the robot (see robot specific tutorials for specific guidance)

Depending on what kind of setup you are planning, you might need to connect the Mimic Controller with the Gigabit switch using the ethernet cable, if for example, you will need to connect more hardware.


⚠️

Important Notice on System Integrity

To ensure full compatibility and stable operation, please only update the software provided by Nordbo Robotics. Updating the operating system or other third-party software may interfere with system performance or disrupt critical integrations.